Liens utiles

IAP-120/120+

Industrial IEEE 802.11 b/g wireless access point.

En savoir plus
Télécharger

• High Speed Air Connectivity: WLAN interface support up to 54Mbps link speed
• Support X-Roaming < 100 ms
• Support wireless load balance
• Highly Security Capability: WEP/WPA/WPA-PSK(TKIP,AES)/ WPA2/WPA2-PSK
(TKIP,AES)/802.1X Authentication supported
• Support AP/Bridge/Repeater/AP-Client Mode
• Switch Mode Supported: Daisy Chain support to reduce usage of switch ports
• Dual redundant Ethernet port support redundant mode (Recovery time < 10ms)
• Secured Management by HTTPS
• Event Warning by Syslog, Email, SNMP Trap, Relay and Beeper
• Rigid IP-30 housing design
• DIN-Rail and panel mounting enabled

	IAP-120	IAP-120+
Physical Ports
10/100Base-T(X) Ports in RJ45 Auto MDI/MDIX	2
P.O.E. PD port	Present at ETH2 Fully compliant with IEEE 802.3af Power Device specifi cation Over load & short circuit protection Isolation Voltage: 1000 VDC min. Isolation Resistance : 108 ohms min
WLAN interface
Operating Mode	AP/Bridge/Repeater/AP-Client
Antenna and connector	2dBi antenna on reverse SMA connector
Radio Frequency Type	DSSS, OFDM
Modulation	IEEE802.11b : CCK, DQPSK, DBPSK IEEE802.11g : OFDM with BPSK, QPSK, 16QAM, 64QAM
Frequency Band	America/FCC : 2.412~2.462 GHz (11 channels) Europe CE/ETSI : 2.412~2.472 Ghz (13 channels)
Transmission Rate	IEEE802.11b : 1/ 2/ 5.5/ 11 Mbps IEEE802.11g : 6/ 9/ 12/ 18/ 24/ 36/ 48/ 54 Mbps
Transmit Power	IEEE802.11b/g : 20dBm Max
Receiver Sensitivity	-81dBm @ 11Mbps, PER< 8%; -64dBm @ 54Mbps, PER< 10%
Encryption Security	WEP : (64-bit ,128-bit key supported) WPA : WPA2 : 802.11i(WEP and AES encryption) PSK (256-bit key pre-shared key supported) 802.1X Authentication supported TKIP encryption
Wireless Security	SSID broadcast disable
Protocol Support
Protocol	ARP, BOOTP, DHCP, DNS, HTTPs, IP, ICMP, SNTP, TCP, UDP, RADIUS, SNMP, STP (IEEE 802.1D)
LED Indicators
Power Indicator	PWR 1(2)(P.O.E.) / Ready : Red On : Power is on and booting up. Green On : Power is on and functioning Normally.
10/100TX RJ45 Port Indicator	Green for port Link/Act at 100Mbps. Amber for port Link/Act at 10Mbps
WLAN LEDs	WLAN Link /ACT : Green WLAN Strength : 1<25%, 2<50%, 3<75%, 4<100%
Fault	Red : Ethernet link down or power down
Fault contact
Relay	Relay output to carry capacity of 1A at 24VDC
Power
Redundant Input Power	Dual DC inputs. 12-48VDC on 6-pin terminal block	Triple DC inputs, 48VDC from PoE and Dual 12~48VDC on 6-pin terminal block
Power Consumption (Typ.)	6 Watts
Overload Current Protection	Present
Reverse Polarity Protection	Present on terminal block
Physical Characteristic
Enclosure	IP-30
Dimension (W x D x H)	54.2(W) x 106.1(D) x 145.4(H) mm (2.13x4.18x5.72 inch.)
Weight (g)	800 g	804 g
Environmental
Storage Temperature	-40 to 85°C (-40 to 185°F)
Operating Temperature	-10 to 70°C (14 to 158°F)
Operating Humidity	5% to 95% Non-condensing
Regulatory approvals
EMI	FCC Part 15, CISPR (EN55022) class A
EMS	EN61000-4-2 (ESD), EN61000-4-3 (RS), EN61000-4-4 (EFT), EN61000-4-5 (Surge), EN61000-4-6 (CS),EN61000-4-8, EN61000-4-11
Shock	IEC60068-2-27
Free Fall	IEC60068-2-32
Vibration	IEC60068-2-6
Safety	EN60950-1
MTBF (Hours) (MIL-HDBK-217F2, GB, GC, 25°C )	352,982	352,594
Warranty	3 years