TGAP-620-M12 Series
Industrial EN50155 IEEE 802.11 a/b/g/n wireless access point with 2x10/100/1000Base-T(X), M12 connector
Industrial EN50155 IEEE 802.11 a/b/g/n wireless access point with 2x10/100/1000Base-T(X), M12 connector
• High Speed Air Connectivity: WLAN interface support up to 300 Mbps link speed
• Highly Security Capability: WEP/WPA/WPA-PSK(TKIP,AES)/ WPA2/WPA2-PSK(TKIP,AES)/802.1X Authentication supported
• Dual Gigabit Ethernet ports support Ethernet redundant mode (Recovery time < 10ms) and switch mode in M12 connector (A-coding)
• Support X-Roaming < 60 ms
• Support wireless load balance
• Support Multiple-SSID to 4 SSID
• Support external SMA antenna installation
• Support AP/Client /Bridge /AP-Client Mode
• Support MAC Filter
• Dual Ethernet ports support Ethernet redundant mode (Recovery time < 10ms) and switch mode in M12 connector (A-coding)
• Wireless connecting status monitoring
• 1KV isolation for PoE P.D. port for TGAP-620+-M12 • Secured Management by HTTPS
• Event Warning by Syslog, Email, SNMP Trap, and Relay output
• Rigid IP-40 housing design
• Wall-mount enabled
TGAP-620-M12 |
TGAP-620+-M12 |
|
Physical Ports |
|
|
100/1000Base-T(X) Ports in M12 Auto MDI/MDIX (8-pin A-coding) |
2 |
2 (Present at ETH2 Fully Compiant with IEEE 802.3af PoE P.D.) |
DIDO port in M12 (A-Coding) |
2(DI x 4 and DO x 4) |
|
RS-232 Console port in M12 (5-pin A-coding) |
115200, 8 ,N ,1 |
|
Antenna Connector |
2 |
|
Relay port in M12 (5-pin A-coding) |
1A@24VDC |
|
WLAN interface |
|
|
Operating Mode |
AP/Bridge/Repeater/AP-Client |
|
Antenna and connector |
2 x Reverse SMA Female |
|
Radio Frequency Type |
DSSS |
|
Modulation |
IEEE802.11b: CCK, DQPSK, DBPSK |
|
Frequency Band |
America/FCC: 2.412~2.462 GHz (11 channels) |
|
Transmission Rate |
IEEE802.11b: 1 / 2 / 5.5 / 11 Mbps |
|
Transmit Power |
802.11a: 12dBm ± 1.5dBm |
|
Receiver Sensitivity |
802.11a: -68dBm ±2dBm@54Mbps |
|
Encryption Security |
WEP: (64-bit ,128-bit key supported) |
|
Wireless Security |
SSID broadcast disable and enable |
|
Protocol Support |
|
|
Protocol |
ARP,BOOTP, DHCP, DNS, HTTP, IP, ICMP, SNTP, TCP, UDP, RADIUS, SNMP, STP, RSTP |
|
LED Indicators |
|
|
Power Indicator |
2 x LEDs, Green for Power on |
|
10/100/1000TX RJ45 Port Indicator |
2 x LEDs, Green for port Link/Act |
|
WLAN LED |
1 x LED, Green for WLAN Link/Act |
|
Fault |
1 x LED, Red for Ethernet link down or power down indicator |
|
Fault contact |
|
|
Relay |
Relay output to carry capacity of 1A at 24VDC(5-pin M12 A-coding) |
|
Power |
|
|
Redundant Input Power |
Dual Power Inputs. 12~48 VDC |
|
Power Consumption (Typ.) |
7 Watts |
7.5 Watts |
Physical Characteristic |
|
|
Enclosure |
IP-40 |
|
Dimension (W x D x H) |
125.6(W) x 65(D) x 196.1(H) mm (4.94 x 2.55 x 7.72 inch.) |
|
Weight (g) |
965 g |
970 g |
Environmental |
|
|
Storage Temperature |
-40 to 85°C (-40 to 185°F) |
|
Operating Temperature |
-25 to 70°C (-13 to 158°F) |
|
Operating Humidity |
5% to 95% Non-condensing |
|
Regulatory approvals |
|
|
EMI |
FCC Part 15, CISPR (EN55022) class A, EN50155 (EN50121-3-2, EN55011, EN50121-4) |
|
EMS |
EN61000-4-2 (ESD), EN61000-4-3 (RS), EN61000-4-4 (EFT), EN61000-4-5 (Surge), EN61000-4-6 (CS), EN61000-4-8, EN61000-4-11 |
|
Shock |
IEC60068-2-27, EN61373 |
|
Free Fall |
IEC60068-2-31 |
|
Vibration |
IEC60068-2-6, EN61373 |
|
Safety |
EN60950-1 |
|
Warranty |
5 years |